Description
MOLUB-ALLOY™ PASTE PL (previously named Optimol™ Paste PL) is especially suited for highly loaded sliding
surfaces as well as for base and thin-film lubrication at high pressures and temperatures.
For larger surfaces and lubricating points with difficult access such as bore holes, threads and gear rims we
recommend the use of MOLUB-ALLOY PASTE PL SPRAY.
Application
For screw connections, press and snug fits at high temperatures up to + 600°C/+ 1112°F
For sliding bearings, bushes and toothed wheels.
On drive trains in the automotive industry.
For base lubrication of slide ways, guides and joints.
For good separation of tool and work piece during hot shaping of metals.
Temperature application range: - 30°C/- 22°F up to about + 450°C/+ 842°F (in case of reduced air supply up to
+600°C/+ 1112°F).
Advantages
Wide range of applications.
Immediate lubricating effect.
Easy spray application.
Economical in use.
Thermally stable.
Excellent emergency running properties due to especially selected solid lubricants.
Maximum load carrying capacity.
Extremely low coefficient of friction.
Good corrosion protection.
Prevents fretting corrosion. Good adhesion and separation.
Prevents stick-slip.
Additional Information
Clean surface. Apply thin layer of MOLUB-ALLOY PASTE PL with a brush or a lint-free cloth. Remove excess
paste. Shake MOLUB-ALLOY PASTE PL SPRAY (article no. 08436) well before use. Hold can about 15 - 20 cm (6
to 8 inches) from lubricating point to apply thin and even layer of lubricant.
Only for paste-specific applications - cannot replace oil or grease lubrication.
Please avoid mixing with other pastes, greases or oils.