Description
Castrol Molub-Alloy™ TF Spray (previously called Opticoating TF Spray) is a powdered solid lubricant with good
adhesion to metal surfaces with high surface finish. It is especially suited for lubrication of tight-fitting components. Its
dry sprayable film is ideal for hard-to-reach lubricating points. Molub-Alloy TF Spray also provides good base lubrication
to eliminate wear, friction and stick-slip. It avoids damaging of sliding surfaces working under extreme loads.
Application
For lubrication and wear reduction at sliding surfaces, gear teeth, spindles, slide ways and iron or non-ferrous
metal guides (not for white metals).
Especially efficient for hard-to-reach lubricating points i.e. bolt holes, threads, gear rims and adjusting spindles
in the wood, paper and glass industries.
For base lubrication of highly loaded sliding bearings, toothed racks, guides, ejector pins and door and adjusting
spindles on airplanes (the lubricity is not affected by dust or aggressive ambient atmospheres).
For width adjusting spindles of tenter frames (dust and lint will not accumulate)
Temperature application range: in ambient air: - 180°C to + 450°C sealed from air: - 180°C to + 650°C under
protective gas: - 180°C to + 1300°C
Advantages
Sprayable, easy handling
Extremely economical in use
Outstanding adhesion to all metal surfaces
Optimum wear protection
Minimum coefficient of friction (μ - 0.04)
Outstanding load carrying capacity
Good separation ability
Dry lubricating film, does not attract or hold dust
Aging-resistant and thermally stable
Complies with international specifications (Bundesamt für Wehrtechnik/Federal Defense Agency: VTL 6810-015,
French spec.: AIR 4223, English spec.: DEF 2304, US spec.: MIL-M 7866B, NATO spec.: S 740)
Additional Information
Thoroughly clean and degrease metal surfaces.
Molub-Alloy TF Spray contains solvents, hence observe handling instructions for solvent-containing products.
Shake spray can well before use. Apply thin and even layer of dry lubricant.