Mobilarma 524

Product Description

Mobilarma 524 is a premium performance product primarily intended as run-in or lay-up lubricant, which provide effective rust preventive films on the internal surfaces of machinery. It is particularly suitable as run-in lubricants for diesel and gasoline engines. The oil displace water from metal surfaces and form strong water-resistant films on the metal surfaces to prevent rust and corrosion. Mobilarma 524 absorbs the water in systems into a water-in-oil emulsion so that the contact surfaces of the machinery still get satisfactory lubrication. Their high level of chemical stability and their anti-wear and detergent properties make them suitable as high quality short-term lubricant.

In most applications, the residual rust preventive films need not be flushed away when the assembly is filled with lubricating oil or hydraulic fluid and put back in service. However, flushing with a charge of lubricating oil to remove the Mobilarma product or its residual film, is recommended if:

1. Mobilarma 524 does not provide the required lubricant characteristics to operate the equipment at rated loads and temperatures

2. Draining of the equipment is difficult and considerable pockets of the Mobilarma 524 cannot be easily removed

3. Contamination of the system oil by Mobilarma 524 could reduce the lubrication performance characteristics (examples; Mobilarma 524 could increase Freon cloud points in compressors or water-in-oil emulsions reduce anti-wear characteristics in high pressure hydraulic systems)

4. Presence of the rust preventive agents reduces the ability of the new oil to separate water in turbine and similar equipment.

Features and Benefits

Mobilarma 524 provide an excellent lubricant that also acts as a rust preventive. This allows safe lay-up of equipment that will not be used immediately but may be operated intermittently at low to moderate loads for short periods of time. These products provide excellent rust preventive performance reducing any potential damage that could otherwise occur in non-operating equipment. This saves clean-up and potential rigorous flushing procedures prior to placing the equipment back in service.

Applications

Run-in oil and lay-up oil for engines and industrial equipment

Turbines that will be out of service for long periods

Hydraulic systems where water is present and the formation of emulsions will not effect operation

Test calibration oil